Compaction is one of the most important steps for many construction projects. A properly compacted base will ensure the stability needed to properly support structures, sidewalks, roadways etc.
Depending on the size or type of job, there are a few different compaction options to choose from, such as vibratory plate compactors, and tamping rammers (otherwise known as a jumping jack). Although the tools used, and compaction requirements may differ by job, the intended outcome is the same; creating a strong stable base that will reduce the severity of settlement, increase resistance, and limits excessive and unwanted movement and volume changes of the soil.
The two most common pieces of equipment for general contracting, that we receive the most questions about are rammers and plate compactors. We’ve found that people aren’t always sure when one may be a better option over the other. Below, we’ll discuss and highlight what you’ll need to take into consideration when choosing between the two.
When choosing between a plate compactor and rammer, it’s important to understand the differences between the soil types. This will help you to determine the type of equipment you’ll need to use to achieve the best results.
Typically there are 2 different soil types:
Granular Soils, like gravel and sand, are loose soils that can be compacted regardless if they’re wet or dry. They tend to crumble when picked up and have no cohesive strength, therefore they can’t typically be molded like cohesive soils.
Cohesive Soils typically have a high clay content and hold together firmly. They need to contain a certain amount of moisture to help ensure proper compaction. If they are too wet or dry, air bubbles or improper compaction may occur.
----------------
Choosing between these machines is not quite as clean-cut as someone might think. While they both compact base material, they compact different soil types best, in very different ways.
Every situation is different and it’s important to fully understand the job requirements and types of soil you’ll be working with, however, a general rule of thumb when it comes to rammers and compactors is:
If you’re doing trench work with cohesive soil, a rammer is typically ideal. Its shape makes it easy to maneuver and the smaller, more focused plate allows for deeper compaction so you won’t need to do numerous passes to make the material sufficiently compact in deep trenches or holes.
If you’re compacting granular soils over large, flat areas, a plate compactor would typically be your best option. Its wider plate size and vibrating nature allows for more uniform layers over a larger amount of square footage.
Truth be told, most contractors encounter circumstances where having both are ideal. Why pit these machines against each other? Add both to your fleet to help you get the job done more effectively, in less time.